胤煌科技-測Zeta電位為什么不能稀釋？

什么是Zeta電位？

Zeta potential is an electrostatic potential that exists very near the surface of particles suspended in liquids1. Zeta potential (ζ) is responsible for particle-particle repulsion forces in colloidal suspensions and thus can be used to predict colloid stability against particle aggregation. Figure 1 illustrates a particle suspended in a liquid along with various notional regions around it.  The“slipping plane” or “shear plane” is where Zeta potential is located versus the potential in the bulk solution. Within this slipping plane, the liquid is bound to the particle while it moves freely outside this boundary. The net potential far from the particle (in the bulk of the liquid) is zero.

Zeta電位是液體中懸浮的粒子很接近表面位置的靜電勢1。Zeta電位(ζ)是由膠體中粒子與粒子間的相互作用造成的，因此它可以用來預測膠體體系里粒子聚集的穩定性。圖1顯示了懸浮在液體中的粒子及其周?chē)母鞣N概念區域。Zeta電位指的是液體中滑動面或者剪切面的電位。在這個滑動平面內，當液體在這個邊界外自由運動時，它與粒子結合在一起。遠離粒子的凈電勢(在液體中)為零。

Figure 1. A negatively charged particle suspended in a liquid. Notional boundaries are shown.

圖1懸浮在液體中的帶負電的粒子及其周?chē)母鞣N概念區域

PS：這個是另外的一種說法，但是要描述的內容是一樣的；

由于分散粒子表面帶有電荷而吸引周?chē)姆刺?hào)離子，這些反號離子在兩相界面呈擴散狀態分布而形成擴散雙電層。根據Stern雙電層理論可將雙電層分為兩部分，即Stern層和擴散層。Stern層定義為吸附在電極表面的一層離子（IHP or OHP）電荷中心組成的一個平面層，此平面層相對遠離界面的流體中的某點的電位稱為Stern電位。穩定層(Stationary layer) (包括Stern層和滑動面slipping plane以內的部分?jǐn)U散層) 與擴散層內分散介質(dispersion medium)發生相對移動時的界面是滑動面(slipping plane)，該處對遠離界面的流體中的某點的電位稱為Zeta電位或電動電位（ζ-電位）。

測Zeta電位為什么不能稀釋？

In aqueous media, Zeta potential is typically generated as the ions on the particle surface dissociate, leaving a net electric charge near the surface surrounded by a cloud of counter-ions. Various types of ions can diffuse in and out through the slipping plane which allows Zeta potential to vary depending on the ion composition in the liquid such as pH. Ions may also participate in chemical reactions within the slipping plane which can affect the Zeta potential. Sample dilution can significantly shift the Zeta potential as ions may adsorb or desorb from the particle. Thus, Zeta potential can be positive or negative, or zero (Iso-Electric Point, IEP) depending on the liquid (solvent) pH or ion type and concentration.

在水相介質中，Zeta電位通常是由于粒子表面的離子離解而產生的，在表面附近留下一個被反離子云包圍的凈電荷。各種類型的離子可以通過滑動面擴散進來和出去，滑動面允許Zeta電位根據液體中的離子組成而變化，例如pH值。離子也可以通過參與滑動面內的化學反應，從而影響Zeta電位。樣品稀釋可以顯著地改變Zeta電位，因?yàn)殡x子可以吸附或者解析顆粒。因此，Zeta電位可以是正的或負的，也可以是零(等電點，IEP)，這取決于液體(溶劑)的pH值或離子的類型和濃度。

測量Zeta電位的方法

Particle-filtration systems may benefit from low Zeta potential levels as aggregated particles are easier to remove. Most other colloidal systems require higher Zeta potentials, e.g. over +/- 20 millivolts in order to maximize shell life. Coatings tend to be more efficient when the particles and coated surface have opposite polarities. Zeta potential normally cannot be directly measured. For example, one cannot place a voltmeter probe against a particle surface in order to measure its surface potential. Instead, Zeta potential is calculated from electrophoretic measurements which measure particle velocity under an applied electric field, i.e. make the particles move and measure their particle mobility (see www.matec。。ｃｏｍ/mas). Thus, the calculated Zeta potential depends on the theory used in these computations to relate particle mobility to Zeta potential. An alternative measurement for large particles or surfaces is to move the liquid against stationary particles, fibers, or surfaces and measure the resulting streaming potential。

顆粒過濾系統可能受益于較低的Zeta電位水平，因?yàn)榫奂w粒更容易去除。大多數其他膠體系統需要較高的Zeta電位，例如超過+/- 20毫伏，以大限度地提高殼體壽命。當顆粒和涂層表面具有相反的極性時，涂層往往更有效。Zeta電位通常不能直接測量。例如，不能將伏特計探頭靠在粒子表面上以測量其表面電位。相反，Zeta電位是通過電泳測量來計算的，電泳測量是在外加電場下測量粒子速度，也就是通過粒子移動并測量其粒子遷移率（見www.yh-tek。。ｃｏｍ/mas）。因此，計算出的Zeta電位取決于這些計算中使用的理論，即粒子遷移率與Zeta電位的關系。另一種測量大顆?；虮砻骐娢坏姆椒ㄊ菍⒁后w移到靜止的顆粒、纖維或表面上，然后測量產生的流動電位。